Today I received my wet shave ensemble that I ordered from Amazon and am excited yes excited about shaving again. I ordered a Safety razor, Boar hair brush, Shaving soap and extra Blades. The reason I am going to start wet shaving is because of the bumps I get on my neck when i “Dry” shave more on the difference on Wet and Dry shaving later. I started reading on how to stop these bumps from occurring and almost all the recommendations pointed to wet shaving so that is what I am going to try.
The primary difference between the wet and dry shaving techniques is the use of water. Wet shaving you get your face thoroughly wet before you start, rinses your razor frequently while you shave, and rinses and tones afterwards. Dry shaving, on the other hand, involves just shaving cream and a razor. Wet shaving is commonly done with a double edged safety razor or strait razor.
A proper wet shave is better for your face and easier on your hair, although it may take some time and nicks to learn. Ideally, it should be undertaken after a shower, when warm water has fully loosened the pores of the face, relaxed the facial muscles, and softened the beard hair. If this is not an option, a towel should be soaked in warm water and placed over the beard for several minutes to mimic, just like at the barber shop, the shower experience. Next, a rich lather of shaving soap is applied to the face, and the face is shaved in short strokes rinsing the blade between each cut. Afterwards, the face should be thoroughly rinsed with warm water before being toned, either with the application of toner or with a cold water rinse, and moisturized. Wet shaving is less likely to cause razor burn, and actually cuts the hairs of the beard, rather than tugging on them, as frequently happens with dry shaving.
Wet shaving well does take some practice, and numerous websites offer tips to men just learning how to wet shave. A few pointers will make the experience more productive. Start by holding the area being shaved taut with your free hand, and gliding the razor over the face with the grain of the beard. Applying pressure to the razor can lead to nicks, and will also start to tug the hair. For final finishing touches, going against the grain of the hair is acceptable. Holding the razor at a 30 degree angle appears to yield the best cut.



